华为路由器开telnet pinghu#show run Now create configuration... Current configuration ! version 1.5.6 login telnet ********************** enable password KZ#`LIX_`B5^N232W9aXV1!! ********************** user 123456 service-type exec password 7 KZ#`LIX_`B7-JEXJQ<%DJQ!! ********************** hostname pinghu dlsw local-peer tcp 150.100.88.10 dlsw remote-peer tcp 150.100.16.10 dlsw bridge-group 1 ! controller e1 0 using E1 ! interface Aux0 async mode interactive encapsulation ppp ! interface Ethernet0 speed auto duplex auto no loopback ip address 150.100.88.10 255.255.252.0 bridge-group 1 ! interface Serial0:0 encapsulation ppp description Connected to center2630-e1-6 10.6.1.25 ip address 10.6.1.26 255.255.255.252 ! exit ip route 131.131.100.8 255.255.255.252 10.6.1.25 preference 60 ip route 150.100.16.0 255.255.248.0 10.6.1.25 preference 60 ip route 150.100.80.0 255.255.252.0 10.6.1.25 preference 60 ! end pinghu# pinghu#show dlsw pe Peers: State pkts_rx pkts_tx drops uptime TCP 150.100.16.10 CONNECT 36 28 0 00:12:02 pinghu# 加上述3条命令. 【 在 wjl1978 的大作中提到：】 :请教 :如何打开 telnet :cisco 的命令是： :line vty 0 4 :login